Rear Shelf Assembly Overview

Rear Shelf Assembly Overview






1 Rear Shelf

• Removing, refer to => [ Rear Shelf, Removing ] Rear Shelf, Removing

• Installing, refer to => [ Rear Shelf, Installing ] Rear Shelf, Installing

• Covers are secured on rear shelf.

2 Parcel shelf seal

• Is connected to rear shelf flange.

• Is removed from outer sides.

• Additional sealing measures should be carried out again.

3 Backing

• For noise insulation.

4 Protective strip seal

• Additional sealing measures should be carried out again.

5 Protective strip

• To install, bond the protective strip with 1K adhesive (D 469 101 A3).

• Removing and Installing, refer to => [ Rear Shelf Protective Strip ] Rear Shelf Protective Strip

6 Parcel shelf trim

• Secure to rear shelf with clip - 7 -.

• To remove trim, protective molding must first be removed.

7 Retaining clip

• Check trim for damage before installing.

8 Retaining clip

• Check protective strip for damage before installing.

9 End piece

10 Rubber stop

• For noise reduction when roof is open.

• Install the stop buffer, refer to => [ Rear Shelf Stop Buffer, Installing ] Rear Shelf Stop Buffer, Installing.

• Stop buffer, adjusting, refer to => [ Basic Setting for Newly Installed CSC Roof ] Basic Setting For Newly Installed CSC Roof

11 Protective cap

• To engage luggage compartment cover.