Roof Pillar Flap, Installing

Roof Pillar Flap, Installing

• Screws are microencapsulated and must always be replaced.

• If the clip - 6 - for the cable - 4 - on the hinge is loose, it must always be replaced.






- Install screws - 2 -, but do not tighten yet.

- Adjust height to other components with closed roof pillar flap - 1 - and tighten screws - 2 -. Tightening specification: 9 Nm.

- Secure cable clip - 3 - on roof pillar flap mechanics.

If clip - 6 - was released, proceed as follows:

- Allow rear lid with rear shelf to tip back until in a center position. The clip must be located in a hinge opening. Support rear lid.

- Secure a new clip on hinge. Check if clip is locked.

- Adjust roof pillar flap. Refer to => [ Roof Pillar Flaps, Adjusting ] Roof Pillar Flaps, Adjusting.