Parking Lamp Bulbs

Parking Lamp Bulbs

Removal


• Note usage and safety notes for halogen lamps, refer to => [ Application and Safety
Notes ] Halogen Headlamps.

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

In order to be able to replace the bulb, it is sometimes necessary to remove neighboring components at the corresponding headlamp.

- Refer to the following table as to which components are to be removed depending on engine version, in order to replace the bulb.






• The following figures show the replacement of the right headlamp bulb.

• The left headlamp bulb is replaced is the same way.

- Twist off housing cover - 2 -.






• Lamp - 1 - is clipped into the reflector.






• When removing lamp - 1 -, the connector is not disconnected first.

- Press retaining tabs - arrows - of lamp socket together and pull lamp socket with lamp out of reflector.






- Pull the lamp socket - 1 - with parking lamp out of reflector as far as the wire lengths permit.

- Remove parking lamp - 2 - from lamp socket - 1 - in - direction of arrow -.

Installation

Install in reverse order of removal, noting the following:

- Push lamp socket into reflector.

• The lamp socket must engage audibly.

• When installing housing cover, check for proper fitting. It is destroyed by entry of water into headlamp.

- Check headlamp for function.