Shock Absorber

Shock Absorber

• Adaptive chassis DCC shock absorber, removing and installing, refer to => [ Rear Shock Absorber ] Rear Shock Absorber.

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1332)

Removing

- Remove the wheel.

- Remove the wheel housing liner.

- Remove coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Remove the bolts - arrows -.






- Remove bolt - arrow -.






- Remove shock absorber.

Installing

Install in reverse order of removal. Note the following:

• The bolted connections of the shock absorber to the wheel bearing housing must only be fastened when the dimension "a" is achieved! Refer to => [ Measure dimension. ] Rear Axle, Lifting to Curb Weight Position

- Insert shock absorber and tighten bolts - arrows -.






- Tighten the bolt - arrow -.






- Install coil spring. Refer to => [ Installing ] Coil Spring.

- Install wheel housing liner.

- Install the wheel and tighten the wheel bolts. Refer to => [ Wheel Bolts Tightening Specification ] [1][2]Specifications.

Tightening Specifications