Window Regulator, Installing

Window Regulator, Installing






- Rotate window regulator - 1 - around cables until regulator can be inserted in door - arrows a -.

- Clean the bolt threads and coat them with locking compound (D 000 600 A2).

- Tighten rear upper and lower screws - 2 - and front screw. Tightening specification: 8 Nm.

- Install front upper screw - 2 -, but do not tighten yet.

- Install the door window. Refer to => [ Door Window, Installing ] Door Window, Installing.

- Raise door window, front upper screw positions itself.

- Tighten upper front screw - 2 -. Tightening specification: 8 Nm.

- Press the cover caps - 3 - into the lower edge of the door.

Door window inclination can be adjusted - arrow b - via oblong hole on lower screws - 2 -.

- Perform window regulator basic setting. Refer to => [ Window Regulator Basic Setting ] Window Regulator Basic Setting

- Adjust the door window.