Operation CHARM: Car repair manuals for everyone.

Trunk / Liftgate: Adjustments






Rear Lid, Adjusting

Vehicle must be standing on its wheels for basic setting of rear lid.

The lid lock is attached directly to the lid. It does not have longitudinal holes and therefore cannot be adjusted.

Stops recognized in other vehicles do not serve to adjust the lid. They stabilize or cushion the lid.

Next, adjusting the rear lid is described in several steps.

To adjust or check the gap dimensions, use special tool (3371)

- Remove the gas strut => [ Gas Strut ] Service and Repair

- Adjust rear lid at striker pin => [ Rear Lid, Adjusting ] Adjustments

- Adjust rear lid at rear lid hinge by loosening screws - 3 - => [ Rear Lid ] Rear Lid

- Adjust rear lid with rear lid hinge by loosening hex head nut - 3 -.





- Adjustment buffer, adjusting => [ Rear Lid, Adjusting ] Adjustments

The rear lid is adjusted properly when it has an even gap dimension overall when closed, it does not rest too far in or out and the contours align.

Striker Pin, Adjusting

- Remove lock carrier cover.





- Disengage the latch bracket - 2 -.

- Bring striker pin - 2 - to rear position - arrow - and tighten screws - 1 -.

- Close the rear lid and check the adjustment.

- Latch bracket - 2 - can be slid in oversized holes by loosening bolts - 1 -.

- Tightening specification for bolts - 1 -: 23 Nm

Adjusting Buffer, Adjusting

The following adjustment is only for the right adjustment buffer. Adjustment for the left adjustment buffer is similar

- Loosen clamping screw - 2 - far enough until it is visible in rubber buffer.





- Now pull notched slider - 1 - out of adjustment buffer.

- Set notched slider to dimension - a = 12.5 mm -.





- Close rear lid to initial locking position using light pressure over the center.

- Open rear lid again.





- Install adjustment buffer locking screw - 1 - to a depth of dimension - a = 25 mm -.

- Check the adjustment.