Removal and Replacement

Breather Assembly

Removing and Installing the Hose/Line Assembly - 4 - from/to the Breather Assembly - 1 -





- Pull the circlip - 2 - up with a screwdriver or pointed tool and remove the hose/line assembly (or plastic line) - 4 - from the breathe assembly - 1 -.

- To install, push the hose/line assembly or plastic line with new O-ring - 3 - into the connection on the breather assembly, until the circlip audibly engages.

- Pull on the line to make sure it is secure.

Removing and Installing the Breather Assembly - 4 - from/to the Slave Cylinder





- To remove, pull the circlip - 2 - up with a screwdriver or pointed tool and remove breather - 4 - from the slave cylinder - 1 -.

- Check the O-ring - 3 - on the clutch slave cylinder. Push the breather assembly onto the slave cylinder connector until circlip engages audibly.

- To check, pull on the breather assembly.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] 02Q Transmission.