Venting Gas-Filled Strut

Venting Gas-Filled Strut

- Clamp the gas-filled strut in the vise in area - x - = 50 mm (2 in.).






Clamping the gas-filled strut must only be done in this area - x -, otherwise there is a risk of an accident.

- Using saw, cut into cylindrical part of strut at point within 1/3 of cylinder's length (measured from cover edge at piston rod end of cylinder).


Always wear eye protection when performing this procedure.

• Cover the area of the separated portion with a clean rag.

• Dispose of fluid and cleaning rag in a proper manner.