Side Panel Trim Molding, GLI

Side Panel Trim Molding, GLI

Removing

- Remove the bolts - 1 - (Torx(R) T25) from the body.





- Remove the side panel trim molding - 2 - in the - direction of the arrow -.

If Equipped

- Slide the retaining track - 2 - forward and loosen as specified - arrow -.





- Remove damaged bolts - 1 -.

• The replacement part number for bolts - 1 - is different from the production number. Contact the replacement parts department.

Installing

- Clean the side panel and retaining track to remove adhesive residue. Isopropyl alcohol is recommended.

If Equipped

- Screw in bolts - 1 -. Tightening specifications: 1.2 ± 0.1 Nm





- Install the retaining track - 2 - while ensuring all bolts fit in the holes and slide the track forward.

All Vehicles

- Lay the side panel trim molding - 2 - over the retaining track - 4 - beginning at the rear.





- Secure the front side of the side panel trim molding - 2 - with a bolt - 1 -. Tightening torque: 2 ±0.5 Nm.

- Remove the protective film - 3 - from the double-sided tape on the side panel trim molding - 2 - using a wedge.

- Secure the side panel trim molding - 2 - by pressing it onto the body.

- Install the remaining bolts - 1 - (Qty. 3). Tightening specifications: 2 ± 0.5 Nm