Door Hinges Assembly Overview

Door Hinges Assembly Overview


The nut for eccentric pin - 9 - must not be loosened under any circumstances. It cannot be secured again using workshop equipment.

• The description applies to the right side. The left side is derived accordingly from this.

• Bolts for door hinges must always be replaced after loosening.

• Hinges are no longer manufactured as separated parts.





1 Door

• Removing and installing, refer to => [ Door ] Door

• Adjusting, refer to => [ Adjusting Door ] Adjusting Door

2 Guide Bolt

• 10 Nm

3 Door Hinge with Door Arrester

4 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

5 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

6 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

7 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

8 Guide Bolt

• 10 Nm

9 Nut

• For the eccentric pin

• Must not be loosened

• Used for making adjustments during production.

10 Door Hinge

• Hinge is no longer manufactured as separated parts.

11 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

12 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening

13 Socket Head Bolt

• 20 Nm + 1/4 additional turn (90°)

• Always replace bolt after loosening