With Manufacturer's Scan Tool

Central Locking, OBD DTC Memory, Erasing, Function 05

NOTE: The vehicle system tester VAG1552 can be used instead of the scan tool VAG1551, however a print-out is not possible.

- Connecting scan tool - Scan Tool, Connecting, initiating On Board Diagnosis (OBD) - Central Locking System OBD, Initiating.

Requirements:
- Malfunction is corrected
- Functional check has been carried out
- DTC memory interrogated again

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons 0 and 5 (the function "Erase DTC memory" is entered with 05).

Indicated on display:

Rapid data transfer Q
05 Erase DTC memory

- Confirm entry with Q button.

Indicated on display:

Rapid data transfer arrowright
Fault memory is erased.

- Press arrowright button.

Indicated on display:

Rapid data transfer HELP
Select function XX

NOTE:
- If this appears in the display, the test sequence has malfunctioned.

WARNING: Fault memory was not interrogated

- Adhere exactly to test sequence: first of all check DTC memory, then erase memory.

- Press buttons 0 and 6 to end the output.

Indicated on display:

Rapid data transfer Q
06 End output

- Confirm entry with Q button.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

- Switch off ignition.
- Disconnect connection to scan tool VAG1551.