Electrical Check

Electrical Check, 09G, 6 Speed A/T OBD

Special tools, testers and auxiliary items required
^ Multimeter VAG1526A or Fluke 83 or equivalent
^ Adapter set VAG1594C
^ Test box VAG1598/14 (basic equipment)
^ Test box VAG1598/48

Supplementary information
^ 6 Spd. Automatic Transmission 09G
^ Electrical Wiring Diagrams, Troubleshooting Component Locations

Check requirements
^ Battery voltage OK
^ Fuses OK
^ Ground connections OK

Note:
^ The socket assignments of test box VAG1598/48 are identical to Transmission Control Module (TCM) J217 contact assignment in the wiring diagram.
^ The specified values are valid for an ambient temperature from 0°C to 40°C.
^ If the readings obtained differ from the specified values, determine fault according to wiring diagram.
^ If the readings obtained differ only slightly from the specified values, clean the sockets and connectors of the testers and test leads and repeat the test. Before replacing the particular components, test the wiring and connections and, particularly if specified values are below 10 O, repeat resistance measurements on the component.

TCM J217 multi-pin connector (52 pin) assignment (sockets on VAG1598/48 )





TCM J217 multi-pin connector (52 pin) assignment (sockets on VAG1598/48 ) - continued





List of test steps (multi-pin connector, 52 pin)
^ Only perform test steps for the relevant component as listed in DTC table and measured value block.





Test Table