Checking Windshield Wiper/Washer System

Checking Windshield Wiper/Washer System

Checking Windshield Wiper/Washer System




Prerequisite:


• S244 Fuse 44 (20A) OK !

• Wiper in off position

• Speedometer OK !

Attention!
DO NOT damage, enlarge or bend connector terminals or cavities by forcing probes into them when performing electrical checks. Always use connector test kit VW 1594 to make the necessary electrical connections.


Preparation:


- Remove lower instrument panel cover
- Remove Wiper/Washer Intermittent Relay J31 ( production control number 377) from relay-panel, location V and VI


Troubleshooting procedure:


- Perform test steps according to table beginning on page
- If specified value/test result is obtained, proceed to next step (test result OK !)
- If specified value/test result is not obtained, use table for troubleshooting and repair
- Use valid wiring diagram for circuit testing
- Disconnect test leads after each step