Left Rear Level Control System Sensor

HID Headlamp

Left Rear Level Control System Sensor

Removing

- Loosen the nuts - arrows -.





- Remove the Left Rear Level Control System Sensor (G76) and bracket.

- Disconnect the connector.

Installing

Install in reverse order of removal, noting the following:

Make sure the coupling rod bracket fits correctly on the rear axle.

- Check the position of the Left Rear Level Control System Sensor (G76) after installing.

• The Left Rear Level Control System Sensor (G76) cannot be adjusted, but it must be checked after it has been installed to make sure the voltage signal is within the specified value range of 2.0 to 3.5 volts.

• If the voltage is outside of the tolerance, then check the following points:

• Left Rear Level Control System Sensor (G76) loose in the bracket.

• The coupling rod on the Left Rear Level Control System Sensor (G76) is bent.

• Electrical connection is properly inserted and engaged.

• If there are no malfunctions here, then perform Guided Fault Finding.