Rear Bumper Access/Start Authorization Antenna

Access/Start Authorization Antennas and Sensors

Rear Bumper Access/Start Authorization Antenna (R136)

Component location of Access/Start Authorization Antenna In Rear Bumper is behind the rear bumper cover.

• No coding, basic setting or adaptation is necessary if Access/Start Authorization Antenna In Rear Bumper is replaced. Erase the entry in the DTC memory in "Guided Fault Finding" with the Vehicle Diagnosis, Testing and Information System (VAS5051B). Refer to => [ Access/Start Authorization Antenna In Rear Bumper, Checking ] Antennae and Sensors For Access/Start Authorization, Checking.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove rear bumper cover.

- Disengage Access/Start Authorization Antenna In Rear Bumper - 1 - from lower section of bumper, paying attention to lengths of connected wires.





- Disengage and disconnect harness connector - 2 - and remove Access/Start Authorization Antenna In Rear Bumper - 1 - from vehicle.

Installing:

Install in reverse order of removal, noting the following:

- Connect harness connector - 2 - to the Access/Start Authorization Antenna In Rear Bumper - 1 - until it engages.





- Insert Access/Start Authorization Antenna In Rear Bumper - 1 - first into mount in bumper base and then press it into its end position until it engages.