Battery Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview

Battery Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview





1 - Positive connection

• Red wire with suitable connection

2 - To terminal 15a

• Connection to terminal 15a:

• Ensure wire is protected by fuse

• Fuse max. 15A

3 - Antenna ground

• Ensure correct ground connection to body

• Antenna location must be treated with suitable corrosion protection

4 - Transmitting/Receiving Antenna

• Installation locations: => Table page => [ Antenna, Transmitted Output and Installation Locations ] Antenna, Transmitted Output and Installation Locations.

5 - Shielded antenna wire

• Wire with coaxial connector

6 - Telephone or two-way radio transmitter/receiver unit

7 - Wiring harness

• Voltage supply positive via read wire, 2.5 mm2 cross section

• Voltage supply negative via brown wire, 2.5 mm2 cross section

• If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section

8 - Fuse Panels

• Install next to battery

9 - To starter

10 - Battery

• Installation location in engine compartment

11 - Negative wire

12 - Body ground