Wheel Cover Trim Assembly Overview

Moldings and Trim

Wheel Cover Trim Assembly Overview

• Front and rear wheel trim is necessary on vehicles with 18 inch rim/tire combination.





1 Front Wheel Trim

• Self-adhesive

• Removing:

- Lightly warm wheel trim with hot air gun (V.A.G 1416) and carefully remove.

• Installing:

- Push on the surface just cleaned with adhesive remover (D 002 000 10).

2 Protective Film

• Must be removed before adhering.

3 Adhesive Tape

• Component of wheel trim.

4 Front Fender

5 Distance Dimension

• Dimension - a -is 190 mm.

6 Rear Bumper Cover

7 Rear Wheel Trim

• Self-adhesive

• Removing:

- Lightly warm wheel trim with (V.A.G 1416) and carefully remove.

• Installing:

- Push on the surface just cleaned with (D 002 000 10).

Assembly Overview from 02.2008

• Front and rear wheel trim is necessary on vehicles with 18 inch rim/tire combination.





1 Front Wheel Cover Trim

• Self-adhesive

• Removing:

- Warm the wheel cover trim with a hot air gun (V.A.G 1416) and carefully remove it.

• Installing:

- Push on the surface just cleaned with adhesive remover (D 002 000 10).

2 Protective Film

• Must be removed before adhering.

3 Adhesive Tape

• Is component of the wheel cover trim

4 Front Fender

5 Distance Dimension

• Dimension - a - is 190 mm.

6 Rear Bumper Cover

7 Rear Wheel Cover Trim

• Self-adhesive, attached to the wheel housing liner by a screw

• Removing:

- Remove the bolt - 8 -.

- Warm the wheel cover trim with a (V.A.G 1416) and carefully remove it.

• Installing:

- Push on the surface just cleaned with (D 002 000 10) and attach it.

8 Bolt

• Tightening specification: 2 Nm