Sunroof Glass Panel, Adjusting Height

Sliding/Tilting Sunroof with Glass Panel, Meritor

Sunroof Glass Panel, Adjusting Height

• The glass panel height adjustment is to be performed after the glass panel has been closed out of sliding position.

Zero position of glass panel for sunroof OK.

- Remove the bellow





- Loosen mounting bolts - 1 - for glass panel of sunroof - 2 -.

- Drive sunroof glass panel into position "open".

- Drive sunroof glass panel into position "closed".

- Perform height adjustment for glass panel for sunroof at front and rear on both sides as follows:

Front panel adjustment:





- a - = 0 to 1 mm lower than roof

- arrow - = driving direction

- Tighten front bolts to 5 Nm.

Rear panel adjustment:





- b - = 0 to 1 mm higher than roof

- arrow - = driving direction

- First tighten center, then rear bolts to 5 Nm.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

• Glass panel must not be higher than roof at any point at front or lower than roof at any point at rear.

- Install bellows.