Sunroof Glass Panel

Sliding/Tilting Sunroof with Glass Panel, Meritor

Sunroof Glass Panel

Removing

- Remove bellows. Refer to => [ Bellows ]. Bellows

- Remove mounting bolts - 1 - on left and right sides.





- Remove glass panel for sunroof - 2 - upward.

CAUTION!
Slotted guide rail must not be driven into "opened" position with sunroof glass panel removed because the rain channel is no longer pressed down by the glass panel and may be wedged in roof.

Installing

• The panel must be installed in the neutral position (panel closed).

Neutral position:

Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.





Link guide - 2 - must be engaged in guide rail (cannot be moved by hand).

If this is not the case, adjust parallel movement. Refer to => [ Parallel Movement, Adjusting ] Sliding/Tilting Sunroof With Glass Panel, Meritor (Overview)

- Insert glass panel for sunroof - 2 - from above and screw in mounting bolts - 1 -.





- Tighten mounting bolts - 1 - lightly.

- Adjusting glass panel for sunroof (height adjustment), refer to => [ Sunroof Glass Panel, Adjusting Height ] Sliding/Tilting Sunroof With Glass Panel, Meritor (Overview)

• Tighten bolts after panel height adjustment (4.5 Nm).

• Install bellows after panel height adjustment.