Sunroof Drive Motor

Sunroof with Solar Panel, Webasto

Sunroof Drive Motor

- Remove lights and operating unit.

Changing Motor - Detection of Pre-selector Switch:

• In order to interrupt the release signal and thereby to activate switch detection, the conditions described below must be met.

• If this is not the case, it may lead to the drive motor incorrectly detecting the preset switch and the selected position is not reached. If this happens, it must be realized that solar panel will remain stationary at a closed switch position approximately 10 cm short of the actual closing position.

CAUTION!
Only remove and install drive motor for sunroof solar panel when roof is closed (zero position).

Requirements for removing and installing the drive: the engine and the ignition must be off, remove the key and open the door.

- Switch off engine and ignition, remove key and open door.

• This state must be maintained up to installation of the drive motor.

• Only remove and install drive motor for sunroof when roof is closed (zero position, refer to => [ Sunroof Drive Motor, Adjusting Neutral Position ] Sunroof With Solar Panel, Webasto (Overview)).

- Remove the bolts - arrows - and remove drive motor for sunroof.





- Unclip and disconnect the connector.

The drive motor bolts are microencapsulated and must always be replaced, 3.5 Nm.