Ribbed Belt Pulley With Freewheel, Bosch

Ribbed Belt Pulley With Freewheel, Bosch

Special tools, testers and auxiliary items required

• Multi-point adapter (VAS 3400)

• Torque Wrench (V.A.G 1332)

Removing:

- Remove generator, refer to => [ Generator ] Generator (2.0L) or => [ Generator ] Generator (3.6L).

- Tighten the generator in a vise at the mounting points.

- Remove protective cap from ribbed belt pulley with freewheel.

- Insert (VAS 3400) into ribbed belt pulley with freewheel of generator using open end wrench 17 mm.

- Insert a multi-point socket insert M10 - 1 - in generator shaft.





- Loosen the threaded connection by rotating clockwise, while counter holding with the box-end wrench.

- Hold ribbed belt pulley with freewheel in place by hand and turn at generator driveshaft until ribbed belt pulley with freewheel can be removed.

Installing:

Install in reverse order of removal, noting the following:

- Next, screw ribbed belt pulley with freewheel onto generator driveshaft by hand until it reaches stop.

(V.A.G 1332) must be rearranged for installing ribbed belt pulley with freewheel as follows:

- Disengage socket - 1 - and pull it off handle part - 2 -.





- Turn around handle part - 2 - of torque wrench 180° and insert socket again.

- Set turning direction of torque wrench to left at socket.

- Insert a multi-point socket insert M10 - 1 - in generator shaft.





- Counter hold (VAS 3400) using 17 mm open end wrench.

- Tighten ribbed belt pulley with freewheel by turning generator driveshaft toward left using (V.A.G 1332).

- Tighten all threaded connections to the specification shown in => [ Fastener Tightening Specifications, Generator, All Vehicles ] Fastener Tightening Specifications, Generator, All Vehicles.