Oil Pressure Sender: Service and Repair

Oil Pressure Switch

Special tools, testers and auxiliary items required

• Socket 24 mm and Jointed Extension (T40175)

Removing

- Remove the noise insulation.

- Remove the left charge air hose clamps - 1 and 2 - and hose.





- Remove the harness connector - 1 - from the bracket and disconnect the connector - arrow - from the oil pressure switch.





- Remove the oil pressure switch using (T40175).





Installing

- Insert the oil pressure switch by hand, then tighten it to 20 Nm.

• In the case of a 1 pin oil pressure switch, check whether the ground wire is connected.

The rest of the installation is basically a reverse of the removal sequence.