Solar Sensor: Service and Repair

Sunlight Photo Sensor

Removing

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

- Mark dimensions "a and b" on the instrument panel with tape.





a = 115 mm

b = 15 mm

CAUTION!
The indirect ventilation trim could get damaged.

The trim is mounted by a screw under the photo sensor.

Lift the trim maximum 15 mm.

- Using the trim removal wedge (3409) unclip the right and left trim at the markings and remove them from the instrument panel.

- Install a long blade screwdriver - 3 - in the direction of the photo sensor - 2 -.





- Place a piece of wood - 1 - for example underneath for protection.

- Press the screwdriver - in direction of arrow - and unclip the photo sensor.

- Disconnect the connector from the sunlight photo sensor (G107).

Installing

- Connect the photo sensor connector and then install it back into the instrument panel.