Light Switch (E1)

Instrument Panel Lamps and Switches

Light Switch (E1)

The following components are integrated with Light Switch:

• Fog Lamp Switch (E7)

• Rear Fog Lamp Switch (E18)

• Headlamp Switch Light (L9)

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Turn light switch rotary knob to 0 position.

- Push in light switch rotary handle - arrow 1 - and turn it slightly toward right - arrow 2 -.





- Hold rotary handle in this position and pull Light Switch on rotary handle out of instrument panel - arrow 3 -.

- Disengage harness connector - arrow - and disconnect the connector from the light switch.





Installing:

- Connect the connector to the light switch.

• For reasons of clarity, vehicle floor carpet is not depicted in the illustration.

- Hold light switch firmly in place and push light switch rotary hand in - 1 - and at the same time rotate it toward the right - 2 -.





- Hold rotary knob in this position and insert light switch into instrument panel - 3 -.

- Turn rotary handle to position 0, release and thus engage switch.