HID Headlamp and Cornering Lamp Bulbs

Parking Lamp

NOTE:
- Function of Left Parking Lamp M1 and Right Parking Lamp M3 can be checked using Output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module J519.
- Illustrations depict replacement of parking lamp at right headlamp.
- Replacement of Left Parking Lamp M1 and Right Parking Lamp M3 are similar.

Removing:
- Switch off ignition and all electrical components and move ignition key or start button into position 0 (preliminary engaged position).

NOTE: During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the "Coming Home / Leaving Home" functions on its own.







- Press wire brackets - 1 - and - 2 - to the side in - direction of arrow -.
- Remove cover cap - 3 - from headlamp.







- Pull the grip piece - 1 - with parking lamp out of reflector as far as the wire lengths permit.







- Remove parking lamp - 2 - from lamp socket - 1 - in - direction of arrow -.

Installing:
Install in reverse order of removal, noting the following:

NOTE:
- When installing cover cap, check gasket for proper fitting. Water intrusion will damage headlamp.
- Do not touch the glass of the lamp bulb, when installing. Your fingers will leave traces of grease on the glass which, when the lamp is switched on, will evaporate and cloud the glass.

- Check headlamp for function.
- Check and adjust headlamp aim if necessary.