Halogen Headlamps Bulbs, Hella

Parking Lamp

NOTE: Left Parking Lamp M1 and Right Parking Lamp M3 can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module J519.

Removing:
- Switch off ignition and all electrical components and move ignition key or start button into position 0 (preliminary engaged position).

NOTE:
- During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the "Coming Home / Leaving Home" functions on its own.
- In order to be able to replace parking lamp, it is sometimes necessary to remove neighboring components at the corresponding headlamp.
- Refer to the tables to determine additional component removal as required, depending on engine.










- Illustrations depict replacement of parking lamp at right headlamp.
- Replacement of Left Parking Lamp M1 and Right Parking Lamp M3 are similar.







- Pull off cover cap - 1 -.







- Pull the lamp socket - 1 - with parking lamp out of reflector as far as the wire lengths permit.







- Remove parking lamp - 2 - from lamp socket - 1 - in - direction of arrow -.

Installing:

NOTE:
- When installing cap, ensure proper seating. Water intrusion will damage headlamp.
- Do not touch the glass of the lamp bulb, when installing. Your fingers will leave traces of grease on the glass which, when the lamp is switched on, will evaporate and cloud the glass.

Install in reverse order of removal, noting the following:
- Check headlamp for function.
- Check and adjust headlamp aim if necessary.