Converter With Socket 12V-230V (U13)

Center Console Lamps and Switches

Converter With Socket 12V-230V (U13)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

CAUTION!
• The Converter with Socket, 12V-230V housing contains chargeable capacitors.

• There is a danger of electric shock.

• The housing of Converter with Socket 12V-230V must not be opened under any circumstances.

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ((3409), screwdriver) will be positioned, using commercially available adhesive tape.

• No repairs may be performed on the harness connector, on the wires and the 230V-outlet.

• If there is a fault at harness connector, at wires, at 230V-socket or in the converter, the complete unit must always be replaced.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Carefully remove trim - 1 -.





- Remove screws - arrows -.





- First pull panel toward rear in - direction of arrow 1 -, then upward in - direction of arrow 2 - and remove panel.





- Disconnect the connector - 1 -.





- On vehicles with heated rear seats, unclip rear heated seat regulating switch from panel.

- Disengage power outlet at retaining lugs - arrows - and disconnect it.





- Remove screws - arrows -.





Installing:

Install in reverse order of removal.