Three Way Catalytic Converter, Checking

Three Way Catalytic Converter, Checking

Test procedure
- Perform a preliminary check to verify the customers complaint. Preliminary Check

Function test
- Perform the function test in Diagnostic Mode 06.

If the specified values are not obtained:
- End diagnosis and switch the ignition off.

If the specified values are exceeded:
- Check the exhaust system for leaks.
- If necessary, repair the leak in the exhaust system.
- Erase the DTC memory. Diagnostic Mode 04 - Erase DTC Memory.
- Perform a road test to verify Repair.

If the DTC does not return:
Repair complete, Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes
- End diagnosis.

If no leaks are found in the exhaust system:
- Replace the catalytic converter including front exhaust pipe.
- Assembly is performed in the reverse of the removal.

Final Procedures
After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. Diagnostic Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

End of diagnosis