Suspension Control Module: Service and Repair

Electronic Damping Control Module

Removing

Component location: behind the right side luggage compartment trim

- Switch off all electrical consumers.

- Remove the ignition key.

- Remove the right luggage compartment side trim.

- Remove the electronic damping control module (J250) - 1 - from the compartment.





- Release and remove the connector - 2 -.

Installing

Installation is the reverse of removal, with special attention to the following:

- Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] Programming and Relearning.