Door Window

Front Door Window

Door Window

Removing

• The following describes removing and installing the right door window. Removing and installing the left door window is identical.

• Bolts - 3 - have a left-hand thread.





- Remove front door trim.

- Pry out cover caps - 2 -.

- Lower door window until clamping screws - 3 - of door window are accessible.

- Loosen bolts - 3 - (do not remove. left-hand thread) and press clamping brackets apart.

• If this cannot be done because of a power window malfunction, remove the window regulator motor and then slide the window down.

- Raise the rear door window and tilt it out of the door toward the front in the - direction of the arrow -.





Installation

• The following describes removing and installing the right door window. Removing and installing the left door window is identical.

• Bolts - 3 - have a left-hand thread.

- Install the door window - 1 - in direction of - arrow a - into the door. Make sure the door window sits correctly inside the window guide.





- Without using pressure, guide the door window into clamping brackets - arrow a -.





- Align door window to window frame - arrow b -.





- Tighten clamping screws - 3 - (quantity: 2 left-hand thread), tightening specification: 8 Nm.

• Bolts - 3 - have a left-hand thread.

- Continue by performing the steps used in removal in reverse order.

• A function test must be performed before door trim is installed.