Muffler With Mountings Assembly Overview

Muffler With Mountings Assembly Overview

Center and rear muffler, separating.







1 - Clamping sleeve
- Installed location
- Tighten bolts evenly
- M8: 25 Nm
- M10: 40 Nm
2 - Suspended mount
- For center muffler
- Replace if damaged
- Secure at underbody
3 - 25 Nm
4 - Bracket
- Secured with crossmember to rear axle subframe
5 - Retaining loop
- Replace if damaged
6 - Left rear muffler
- Original equipment as one unit with center muffler. For repairs, replace each separately.
- Separating exhaust system.
7 - Suspended mount
- For rear muffler
8 - Right rear muffler
- Original equipment as one unit with center muffler. For repairs, replace each separately.
- Separating exhaust system.
9 - Center muffler
- Original equipment as one unit with rear muffler. For repairs, replace each separately.
- Separating exhaust system.







Center Muffler Mount to Underbody
Mount - 2 - is installed on underbody in connection with shield - 3 - and fuel tank tension strap - 4 -.

Tightening specification for bolts - 1 - : 25 Nm.







Clamping Sleeve Location
- Install clamping sleeve so that bolt end - arrow - does not project beyond lower edge of clamping sleeve.
- Threaded connection points toward the right.







Installation Position of Clamping Sleeve (for the event of repairs)
- Install clamping sleeve so that bolt end - arrow - does not project beyond lower edge of clamping sleeve.
- Threaded connection points toward the right.