Front Door Window Regulator: Service and Repair

Front Door Window

Window Regulator Motor

Removing

- Remove front door trim.





- Fix window using adhesive tape so that it does not slip down.

- Disconnect all harness connectors - 3 -.

- Remove the three bolts - 2 -.

- Remove window regulator motor with control module - 1 - from subframe.

Installation

CAUTION!
It is necessary to code the additional functions and pinch protection each time a new window regulator motor (door control module) is installed.

- Place window regulator motor on and pull door window lightly up and down so that splines are located better between motor and cable drum.





Tightening specification for window regulator motor screws - 2 -: 3.5 Nm

- Code the new window regulator motor using the (VAS 5051 A).

- After coding, let the window regulator work in the one-touch up/one-touch down mode and pull the switch for 2 seconds. This way the window regulator recognizes it upper stop.

- Continue by performing the steps used in removal in reverse order.