Sealing Flange Assembly Overview

Sealing Flange Assembly Overview

Note:
^ Secure engine to engine and transmission holder VAS 6095 when working on engine.





1 - 100 Nm + 1/2 turn (180°)
^ Replace
^ Use counter-holder tool T10069 for loosening and tightening
^ Tighten using torque wrench V.A.G 1601

2 - Vibration damper
^ Use counter hold T10069 to remove and install

3 - 10 Nm
4 - Sealing flange
^ Coat sealing surfaces with sealant D 176 501
^ With seal

5 - Cylinder block
6 - Sealing flange
^ Coat sealing surfaces with sealant D 176 501

7 - Seal
^ Remove using pulling hook T20143/2
^ PTFE version of oil seal,

- Identification: no inner coil spring

^ Do not additionally oil or grease sealing lip of oil seal
^ Before installing, remove oil remains from crankshaft journal with a clean cloth

8 - Intermediate plate
9 - Dual mass flywheel
10 - 60 Nm + 1/4 turn (90°)
^ Replace
^ To loosen or tighten, use counter hold T10044 (with 5 mm spacers), or counter hold T10069.

11 - 25 Nm