Accelerator Pedal Module

Accelerator Pedal Module

Special tools, testers and auxiliary items required

• Release tool (T10238)

Removing

- Remove the steering column cover fasteners - arrows - and cover.





- Pry out the cap - item 4 - in => [ Accelerator Pedal Module Assembly Overview ] Accelerator Pedal Module Assembly Overview using a screwdriver.

- Remove the bolt.

- Slide the (T10238) as shown into the openings designated for it until it stops and remove the accelerator pedal module.





- Disconnect the electrical connector from the accelerator pedal module. Do this by pressing the connector securing element down.

Installing





- Connect the electrical connector - 2 - to the accelerator pedal module.

The connector must engage audibly.

- Press the accelerator pedal module onto the securing studs - 6 -.

- Insert the centering pin - 7 - into the hole on the vehicle floor.

- Secure the accelerator pedal module with the bolt - 3 -, tightening specification: 10 Nm, and install the cap - 4 -.

- Reinstall the steering column cover.