Alternator

Generator (CBRA)










Tightening sequence for the sub-assembly bracket on the cylinder block, vehicles with A/C system

Procedure
- Position sub-assembly bracket on cylinder block.

NOTE: Insert all bolts before tightening to the specification.

- Tighten sub-assembly bracket mounting bolts in the following sequence:

A - Cylindrical flange screw, M8 x 28, 23 Nm
B - Cylindrical flange screw, M8 x 28, 23 Nm
C - Cylindrical flange screw, M8 x 50, 23 Nm
D - Cylindrical flange screw, M8 x 50, 23 Nm
E - Cylindrical flange screw, M8 x 50, 23 Nm
F - Cylindrical flange screw, M8 x 50, 23 Nm