Radio and Radio Navigation System, Rabbit Sedan

Radio, Multimedia, Navigation

Radio and Radio Navigation System, Rabbit Sedan

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing

• Refer to the correct chapter for the individual unit when removing and installing:

RCD 300 radio system, refer to => [ RCD 310 Radio Connection Overview ] RCD 310 Radio Connection Overview

RCD 500 radio system, refer to => [ RCD 500 Radio Overview ] RCD 500 Radio Overview

Premium Sound System, refer to => [ Premium Sound System ] Premium Sound System

RNS 300 radio navigation system, refer to => [ RNS 300 Radio Navigation System ] RNS 300 Radio Navigation System

RNS MFD 2 and DVD radio navigation system, refer to => [ RNS 510 Radio Navigation System Overview, Rabbit Sedan ] RNS 510 Radio Navigation System Overview, Rabbit Sedan

RNS 510 radio navigation system, refer to => [ RNS 510 Radio Navigation System ] RNS 510 Radio Navigation System

•

Before starting repair work, perform the following:

- If necessary, remove CDs remaining in the unit. Refer to => operating instructions.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

Now, perform the following work procedure:

- Remove upper cover with air outlets out of instrument panel center far enough so that radio panel bolts lying beneath are accessible.

- Remove screws - arrows -.





- Using trim removal wedge (3409), carefully pry out cover of center console in area of - arrows - and remove the panel.





- Remove bolts - arrows - on radio unit.





- Pull radio unit out of installation compartment far enough until harness connectors on rear side of radio unit are accessible.

- Press together the connector lock in direction of - arrows -.





- Then swing mounting bracket up in direction of - arrow - and disconnect harness connector.





- Disengage harness connectors - arrow - from antenna connections and disconnect them.





Installing

- Connect and engage harness connectors to radio unit.

- Slide radio unit straight into instrument panel.

• While sliding in the radio unit, under no circumstances press on the display or control buttons since the radio unit may be damaged by doing this.

- Secure radio unit with 4 bolts - arrows -.





- Reinstall cover for center console.

- Check coding of radio unit and code radio unit again if necessary.

Radio unit coding, refer to => [ Radio Components, Adapting ] Radio Components, Adapting