Intake Manifold and Attachments

Intake Manifold and Fuel Rail Assembly Overviews

Intake Manifold and Attachments





1 Crankcase Ventilation Breather Hose

• From cylinder head cover.

2 Ventilation Hose

3 Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 (N80)

4 Vacuum Hose

• From the Leak Detection Pump (LDP) (V144).

5 Bolt

• 9 Nm

6 Fuel Rail

• Assembly overview, refer to => [ Fuel Rail and Injectors ]. Fuel Rail and Injectors

7 Fuel Supply Line

8 Gasket

• Replace

• Note the installed position:

Casting mark points upward.

9 Intake Manifold

• Removing and installing, refer to => [ Intake Manifold ] Intake Manifold.

10 Rubber Bushing

11 Intake Manifold Support

12 Bolt

• 25 Nm

13 Nut

• 20 Nm

14 O-ring

• Replace if damaged.

15 Manifold Absolute Pressure (MAP) Sensor (G71 )

16 Bolt

• 3.5 Nm

17 Coolant Connections

• Phased-in introduction of throttle valve control module without coolant heating.

18 Bolt

• 6.5 Nm

19 Throttle Valve Control Module (J338)

• With throttle drive (for Electronic Power Control (EPC)) (G186), throttle drive angle sensor 1 (for EPC) (G187) and throttle drive angle sensor 2 (for EPC) (G188).

• When replacing, erase the adaptation values and adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to vehicle diagnosis, testing and information system"Guided Functions".

20 Seal

• Replace if damaged.