Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060A)

Removing

- Remove the noise insulation.

- Remove the front part of the right front wheel housing liner.

Removing the Air Conditioning (A/C) Compressor Ribbed Belt

- Mark the direction of rotation of the ribbed belt.

- Rotate the tensioner - 1 - as shown using a 15 mm box end wrench - A - in the - direction of the arrow - and secure using the (T10060A).





- Remove the A/C compressor ribbed belt.

Removing the Generator and Coolant Pump Ribbed Belt

- Relieve the tension on the tensioner - 1 - for the A/C compressor ribbed belt (pull out the (T10060A)).

- Mark the running direction of the generator and coolant pump ribbed belt.

- Insert the (T10060A) into the tensioner - 2 -.





- Rotate the tensioner - 2 - using a 15 mm box end wrench - A - in the - direction of the arrow - and secure using the (T10060A).

- Remove the generator and coolant pump ribbed belt.

Installing

Installation is performed in the reverse order of removal, noting the following:

- Place the generator and coolant pump ribbed belt onto the pulleys, then lastly around the idler pulley - 3 -.





- Rotate the A/C compressor pulley before tensioning the generator and coolant pump ribbed belt. Make sure the generator and coolant pump ribbed belt is seated correctly on the pulleys.

- Before installing the A/C compressor ribbed belt, secure the tensioner using (T10060A).

• When installing the ribbed belt, note the direction of rotation of the belt and be sure that it is seated correctly on the pulley.

- Start the engine and check the belt running.