Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness Overview

Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness Overview





1 - Positive Connection

• Red wire with suitable connection

2 - To terminal 15a

• Connection to terminal 15a. Refer to

• Ensure wire is protected by fuse

• Fuse max. 15A

3 - Antenna Ground

• Ensure correct ground connection to body

• Antenna location must be treated with suitable corrosion protection

4 - Transmitting/Receiving Antenna

• Installation locations, refer to => [ Transmitted Output, Antenna Installation Locations, Golf from 2004 ] Transmitted Output, Possible Installation Locations.

5 - Shielded Antenna Wire

• Wire with coaxial connector

6 - Telephone or Two-Way Radio Transmitter/Receiver Unit

7 - Wiring Harness

• Voltage supply positive via read wire, 2.5 mm2 cross section

• Voltage supply negative via brown wire, 2.5 mm2 cross section

• If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section

8 - Fuse Holder

• Install next to battery

9 - To Starter

10 - Battery

• Installation location in engine compartment

11 - Negative Wire

12 - Body Ground