Front Door

Door

• Removing and installing is described only for the right door. Removing and installing the left door is similar

Removing





- Release bellows - 6 - by pressing on locking mechanism - arrow a - and remove bellows from A-pillar.

- Swivel locking lever - 7 - downward - arrow b - and disconnect electrical harness connector - 8 - from connector station.

- Remove screws- 4, 5 and 11 - using door adjustment wrench (3320) and bit insert (3320/3) from hinge.

- Pull door in - direction of arrow - from guide bolts - 2 and 9 -.

Installing

To install, perform the steps used for removal in reverse order.

- Bolts - 4, 5 and 11 - tightening specification: 50 Nm.

• Screws - 4, 5 and 11 - must always be replaced.

- Observe gap dimension of front door