RNS 510 Connector Overview
RNS 510 Connector Overview
1 Multi-Pin Connector 1, 8-Pin
• Multi-pin connector assignments, refer to => [ 8-Pin Connector 1, Speaker Outputs ].
2 Multi-Pin Connector 2, 8-Pin
• Multi-pin connector assignments, refer to => [ 8-Pin Connector 2, Voltage Supply Wires and CAN Bus ].
3 Multi-Pin Connector 3, 12-Pin
• Multi-pin connector assignments, refer to => [ 12-Pin Connector 3, Telephone and Microphone Signals ].
4 Multi-Pin Connector 4, 12-Pin
• Multi-pin connector assignments, refer to => [ 12-Pin Connector 4, CD Changer Control and Audio Input Signals ].
5 Multi-Pin Connector 5, 26-Pin
• Multi-pin connector assignments, refer to => [ 26-Pin Connector 5, Audio and Video ].
6 Connectors 6, Antenna
• Multi-pin connector assignments, refer to => [ Connector 6, Antenna ].
8-Pin Connector 1, Speaker Outputs
1 Right rear speaker, positive
2 Right front speaker, positive
3 Left front speaker, positive
4 Left rear speaker, positive
5 Right rear speaker, negative
6 Right front speaker, negative
7 Left front speaker, negative
8 Left rear speaker, negative
• When using an amplifier, the same terminal assignment for Line-In are used for the amplifier. The radio unit is factory programmed from " Output Stage Power 26dB" to "Output Stage Line Out 12dB".
8-Pin Connector 2, Voltage Supply Wires and CAN Bus
9 CAN bus high
10 CAN bus low
11 Display voltage supply, positive, optional only on the Low radio version
12 Voltage supply, negative, terminal 31
13 Display HS CAN bus low, optional only on the Low radio version, not for Midline
14 Display HS CAN bus high, optional only on the Low radio version, not for Midline
15 Voltage supply, positive, terminal 30
16 Control signal, antitheft protection, SAFE, positive
12-Pin Connector 3, Telephone and Microphone Signals
1 Microphone input, negative
2 AUX output, audio, right
3 AUX output, common signal ground
4 Microphone output, minus
5 Left telephone audio input signal, negative
6 Right telephone audio input signal, negative
7 Microphone input, positive
8 AUX output, audio, left
9 Microphone output, positive
10 Telephone mute (radio mute)
11 Left telephone audio input signal, positive
12 Right telephone audio input signal, positive
12-Pin Connector 4, CD Changer Control and Audio Input Signals
1 Left input AUX signals
2 AUX signal ground
3 CD changer, audio signal ground
4 CD changer, voltage supply, positive, terminal 30, contact continuous power handling greater than 1A, short-term peak power handling 5A
5 not used
6 CD changer, data out (data exchange for CD changer control from radio navigation system to CD changer)
7 Right input AUX signals
8 CD changer, left port audio, CD/L
9 CD changer, right port audio, CD/R
10 CD changer, control wire, switched positive
11 CD changer, data in (data exchange for CD changer control from CD changer to radio navigation system)
12 CD changer, clock (internal test protocol for monitoring data flow)
26-Pin Connector 5, Audio and Video
1 Reserved for protocol debug RX
2 Reserved for protocol debug TX
3 Not used
4 Video signals input, RGBS, negative
5 Not used
6 Internal universal cellular telephone preparation, handy detect
7 Internal universal cellular telephone preparation, cradle and description of key functions
8 Internal universal cellular telephone preparation, cradle, antenna diagnosis
9 Video signals input, RGBS, negative
10 Right video signal input NF
11 Video signal input, shielding mass
12 Video signal input, synchronization vertical and horizontal
13 Video signal input, green
14 Not used
15 Not used
16 Not used
17 Not used
18 Not used
19 Internal universal cellular telephone preparation, cradle, negative
20 Internal universal cellular telephone preparation, switched terminal 30
21 Not used
22 Video signal input NF, negative
23 Left video signal input NF
24 Video signals input, RGBS, negative
25 Video signal input, blue
26 Video signal input, red
Connector 6, Antenna
1 Terminal connector antenna radio reception AM and FM2, Double Fakra, no coding, impedance 50 Ohm, color cream white
2 Terminal connector antenna radio reception FM1, Double Fakra, coding B, impedance 50 Ohm, color cream white
3 Terminal connector antenna navigation, Fakra, coding C, impedance 50 Ohm, color signal blue