Engine Assembly - Fastener Tightening Specifications

Fastener Tightening Specifications





Engine Mount





1. = 40 Nm + 90° (1/4) additional turn1)

2. = 20 Nm + 90° (1/4) additional turn1)

3. = 60 Nm + 90° (1/4) additional turn1)

1) Always replace

Transmission Mount





A = 40 Nm + 90° (1/4) additional turn1)
B = 60 Nm + 90° (1/4) additional turn1)

1) Always replace

Pendulum Support





• First install the pendulum support to the transmission and then to the subframe.

A Strength category 8.8 = 40 Nm + 90° (1/4) additional turn 1)
A Strength category 10.9 = 50 Nm + 90° (1/4)) additional turn 1)
B = 100 Nm + 90° (1/4) additional turn1)

1) Always replace

Removing: Always remove bolt - B - first and then bolts - A -.

Installing: First tighten bolts - A - and then bolt - B -.