Removal and Installation

Jump Start Point with Suppressor

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

Removing

- Turn off the ignition and all electrical consumers.

- Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Disengage retaining clip - arrow A - and open cover - 1 - over positive pole pick-up.





- Disengage cover - 2 - over electrical wires in - direction of arrow B -.

- Remove nuts - 5 - and - 6 - at positive cables.





- Disconnect electrical harness connector - 1 - at suppressor - 4 -.

- Unscrew bolt - 3 - and remove positive pole pick-up - 2 - with suppressor from retainer.

Installing

Install in reverse order.

- Tighten all threaded connections to specified torque. Refer to => [ Specifications ] Specifications.

- On batteries with central venting, connect venting hose to battery.

- Reconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

CAUTION!
Central battery venting hose must not be kinked, closed and/or damaged. Battery acids pose health risks and are explosive. Carefully route the hose and ensure the battery can vent freely and not into inside of vehicle.