Lower Transverse Link

Front Wheel Drive

Lower Transverse Link

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1332)

Removing

- Remove wheel.

- Remove coil spring. Refer to => [ Coil Spring ]. Coil Spring

- Remove bolt - arrow - for lower transverse link - 1 -.





Vehicles with automatic vertical headlamp aim control

- Remove the bolts - 1 - from the lower transverse link.





Continuation for all vehicles

- Mark, for example using a felt-tip marker, position of eccentric bolt - arrow - to subframe.

- Disengage rear exhaust system and lower.

- Remove bolt - arrow -.

- Remove lower transverse link.

Installing

- Insert lower transverse link into vehicle and tighten the bolts by hand.

Only bolt on transverse link if dimension a is reached => [ Measure Dimension ] Rear Axle in Curb Weight Position!

- Connect the upper transverse link to the subframe and tighten the new nut - arrow - to the tightening specification only.





- Note applied marking of eccentric bolt - arrow - to subframe.

- Suspend rear exhaust system.

Vehicles with automatic vertical headlamp aim control

- Install the bolts - 1 - to the lower transverse link.

Continuation for all vehicles

- Tighten bolt - arrow - for lower transverse link - 1 -.





- Install coil spring. Refer to => [ Coil Spring ]. Coil Spring

- Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] Specifications.

- Perform vehicle alignment. Refer to => [ Vehicle Alignment Procedure Overview ] Vehicle Alignment Procedure Overview.

Tightening Specifications