Rearview Camera System Control Module

Rearview Camera System Control Module

Control module is installed in luggage compartment behind right side wall trim.

Removal

Before starting repair work, perform the following points:

- Turn off the ignition and all electric consumers and remove the key.

- Remove center loading floor - A - in luggage compartment.






- Remove cover from lock carrier.

- Remove tie-downs - arrows -.






- Remove screw - A - and remove right loading floor.






- Remove right D-pillar trim.

- Remove screws - A - and unclip interior light - B - from trim.






- Unclip trim from D-pillar in - direction of arrow -.






- Unclip trim at side window in - direction of arrow -.






- Carefully swing trim - 1 - as far in - direction of arrow - so that control module for rear view camera system - A - is accessible.






- Press both locking mechanisms - arrows - and remove control module for rear view camera system.






• It is possible that the control module is also secured with Velcro on the bottom. Then, carefully detach control module from base plate.

- Press locking mechanism - A - and fold over the bracket in direction - B -. Then disconnect harness connector from control module.






- Press locking mechanism - A - and pull harness connector out of control module in direction - B -.






Installation

Install in reverse order of removal.

If necessary, replace Velcro strips - arrows - on bottom of control module.

Only if the control module has been replaced

- Calibrate the system. Refer to => [ Rearview Camera System, Calibrating ] Rearview Camera System, Calibrating.