Engine, Installing

Engine, Installing


When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:

• Route lines of all types (for example, fuel, hydraulic, Evaporative Emission (EVAP), coolant, refrigerant, brake fluid and vacuum) and electrical wiring so that the original path is followed.

• To prevent damage to the lines, make sure there is sufficient clearance to all moving or hot components.

Installation is performed in reverse order. When doing this note the following:

- Make sure the centering sleeves for the engine to transmission are installed in the cylinder block. Install if necessary.

- Reconnect all lines, hoses and connections that were disconnected for the removal sequence.

- Electrical connections and routing.

- Connect the Air Conditioning (A/C) lines.

- Top off the fluid level for the power steering. Refer to Fluid Capacity Tables Rep. Gr. 03.

- Fill the coolant. Refer to => [ Draining and Filling ] Draining and Filling.

- Check the headlamp adjustment, correct if necessary. Refer to Maintenance Procedures Rep. Gr. 03 Maintenance Procedures.

- Perform a test drive and check all Diagnostic Trouble Code (DTC) memories. Refer to "Guided Fault Finding" in the vehicle diagnosis, testing and information system VAS 5051 or VAS 5052.

Tightening Specifications