Headlamp Range Control Module

Headlamp Range Control Module

• Illustrations depict replacement of Headlamp range control module at left headlamp.

• Replacement procedure of Left Headlamp Range Control Module (J567) and of Right Headlamp Range Control Module (J568) is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove mounting bolts - arrows - of adjusting shaft for lateral adjustment.






- Remove adjusting shaft for lateral adjustment.

- Remove mounting bolts - arrows - of headlamp range control module - 1 -.






- Remove headlamp range control module - 1 - out of housing cut-out.

- Unclip connector retaining bracket for gas-discharge lamp - 1 - in - direction of arrow - and disconnect connector.






- Press catch of connector for headlamp range control module - 2 - in - direction of arrow - and disconnect connector.

Installation

Install in reverse order of removal. Note the following:

• Make sure seal has proper seating when installing headlamp range control module. It is destroyed by entry of water into headlamp.

• After installing a new control module, it must be coded:

Coding Left Headlamp Range Control Module (J567) => [ Left Headlamp Range Control Module, Coding ] Left Headlamp Range Control Module (J567), Coding.

Coding Right Headlamp Range Control Module (J568) => [ Right Headlamp Range Control Module, Coding ] Right Headlamp Range Control Module (J568), Coding.

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.