12-way Seat

12-way Seat

• Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the same manner.

Removing

CAUTION!
Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

- Position seat as far forward as possible using fore/aft adjustment.

- Remove belt anchor. Refer to => [ Belt Anchor ] Belt Anchor.

- Remove covers from both spindles - 1 -. Refer to => [ Seat Rail Covers ] Seat Rail Covers.

- Remove caps - 2 - and - 3 - from both seat rails. Refer to => [ Seat Rail Covers ] Seat Rail Covers.

- Remove bolts - 4 - (45 Nm) from both seat rails.

• The bolts are microencapsulated and must therefore be replaced after every removal.

• Before installing the new bolts, the threads of the corresponding nuts must be cleaned.





- Position seat as far back as possible using fore/aft adjustment.

- Remove covers from both spindles - 1 -. Refer to => [ Seat Rail Covers ] Seat Rail Covers.

- Remove covers - 2 - from the outer seat rail. Refer to => [ Seat Rail Covers ] Seat Rail Covers.

- Remove bolts - 3 - (45 Nm) from both seat rails.

• The bolts are microencapsulated and must therefore be replaced after every removal.

• Before installing the new bolts, the threads of the corresponding nuts must be cleaned.





- Disconnect the vehicle batteries.

- Raise front of seat until wiring harness and coupling station under seat are accessible.

CAUTION!
Electrostatic discharges can lead to an unintended deployment of the airbag. Therefore the technician must discharge static electricity from the body before separating the ignition and ground wiring. This is done, for example, by briefly touching the body or the door striker or pin.

- Depending on vehicle equipment, disconnect wiring harnesses - 1 - from coupling station under seat.

- Connect the Airbag Adapter (VAS 5232/1) or Airbag Adapter (VAS 6229) to the connector - 2 -.

- Lift seat out of vehicle.





Installation

- To install, perform the steps used for removal in reverse order.

- Switch on ignition.

Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions

CAUTION!
Make sure that no persons are in the vehicle.

- Connect battery.