Crankshaft, Cylinder Block - Fastener Tightening Specifications

Fastener Tightening Specifications





• 1 Always replace

• 2 Install using locking compound (D 000 600 A2)

• 3 Only use bolts with a strength category of 10.9

• 4 The contact surfaces of the adjuster wheel and bolt head must be dry when installing

• 5 Tightening specification affects the function of the knock sensor

• 6 Tighten in a diagonal sequence and in steps

Sealing Flange (Transmission Side) Bolt Tightening Sequence and Specification





Tighten the sealing flange bolts in stages as follows:

- Tighten the bolts - 1 - to 5 Nm.

- Tighten the bolts - 2 - to 23 Nm.

- Tighten the bolts - 1 - to 10 Nm.