Drive Plate with Overload Protection

Drive Plate with Overload Protection

- Remove the A/C compressor. Refer to => [ A/C Compressor with Drive Unit, Engine Code BAR ] A/C Compressor with Drive Unit, Engine Code BAR.

Removing

- Remove bolts - A -.





• User a commercially available band wrench with webbed band to counterhold the drive plate - C -.

Installing

- Position drive plate with overload safeguard - B - onto drive plate - C -.

- Insert bolts - A - and tighten them by hand.

- Check run-out of drive plate - B -. Refer to => [ Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] Adjustments.

- Tighten the bolts - A - tightening specification 10 Nm.

- Check run-out of drive plate - B - again. Refer to => [ Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] Adjustments.